Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 260

2
ficonShow
Incident Count
Link Incident Description
Link Incident Type
Listener PID
Listener Port Type
Listener Port WWN
Listener Type
Conditional
Unconditional
Manufacturer
Model Number
Node Parameters
Parameters
Parm
228
Displays the incident count. This number increases by 1 for each incident
within the individual switch.
Same as Link Incident Type.
Indicates the link incident type as one of the following:
Bit-error-rate threshold exceeded
Loss of signal or synchronization
NOS recognized
Primitive sequence timeout
Invalid primitive sequence for port state
Same as PID.
Same as Port Type.
Displays the channel HBA port World Wide Name.
Indicates the listener type as follows:
This port receives a link incident record if no other recipients from the
established registration list have been chosen.
This port is always chosen as a recipient of a link incident record.
Displays the manufacturer name or code.
Displays the model number.
Same as Parameters.
Displays the node type for the switch in three bytes, 0xAABBCC:
Byte AA 0x20
FC-SB-2 and updates.
Byte BB 0x0a
Switch.
Byte CC 0x00
Port number. It is dynamically assigned whenever a link incident occurs.
Displays the incident node parameters type in three bytes, 0xAABBCC:
Byte AA
0x00 Reserved.
0x20 FC-SB-2 and updates.
0x40 Other FC-4s including FCP and updates.
0x60 FC-SB-2 and updates and other FC-4s including FCP and updates.
0x80 FC-4 support not specified.
0xa0 Reserved.
0xc0 Reserved.
Fabric OS Command Reference Manual
53-1000436-01