Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 484

2
portCfg
mirrorport -- Configures mirror port on the local port.
Usage: portCfg mirrorport slot/][ge]port mode
fastwrite-- Configure FC port for FC Fastwrite
452
iipaddr Specifies the interface protocol as IP and the IP address on the GbE port. Use
this parameter to bring up a native IP interface for link-level diagnostics,
connectivity, and characterization of SLA. Specify the IP address on this GigE
port. Also use for route entries and FCIP tunnel establishment. a.b.c.d format.
macaddr Specifies the MAC address, which corresponds to the IP address in the ARP
table.
netmask Specifies the subnet mask for the specified port or route. Uses a.b.c.d format.
mtu_size Specifies the maximum transfer unit (MTU) size for the IP interface. For GE
ports on a Brocade 7500 or an FR4-18i blade in a Brocade 48000, valid
values are from 1500 to 2348. On an FC4-16i in a Brocade 48000 valid
values are from 1500 to 8256. For v5.3.0, valid MTU size for Brocade 7500
or an FR4-18i blade are 1260 to 2348.
gateway Specifies the gateway IP address for the route.
metric Specifies the link metric associated with the route. Valid values are 0 to 255.
The default is 0.
tunnel_id Specifies the FCIP tunnel on the GbE port. Valid values are 0 through 7.
local_ipaddr Specifies the IP address for the specified port.
remote_ipaddr Specifies the remote-side IP address of an FCIP connection.
comm_rate Specifies the committed traffic rate, in Kbit/sec, on the FCIP tunnel. Valid
values are 1,544 to 1,000,000, and 0 for uncommitted.
A mirror port is used to output mirror traffic configured by the
command. You will be prompted to confirm that the port specified will be
enabled as a mirror port. Once a port is configured as a mirror port, the
port can only be used as part of a mirror connection.
Valid modes for mirrorport are:
--disable Disables the configuration. When disabled, a port cannot be a mirror port.
--enable Enables the configuration. When mirrorport is enabled to a port, a mirror
connection can use this port to mirror traffic.
Port options for mirrorport are:
slot For bladed systems only, specify the slot number of the port to be
configured, followed by a slash (/).
port Specify the number of the port to be configured, relative to its slot for bladed
systems. Use
Enables or disables FC Fastwrite between two Brocade 7500 routers or two
Brocade 48000 directors with an FR4-18i blades connected by Fibre Channel
ISLs. The blade first should be enabled for FC fastwrite using fastWriteCfg.
fastWriteCfg can also be used to list all the ports configured for FC fastwrite.
Usage: portCfg faswrite [slot/][ge]port mode
switchShow for a list of valid ports.
portMirror
Fabric OS Command Reference Manual
53-1000436-01