Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 726

2
sysShutdown
For the FR4-18i AP blade, to perform a system shutdown from the active CP:
For the FR4-18i AP blade, to perform a system shutdown from the standby CP:
See Also haDisable, switchShutdown
694
switch:admin> sysshutdown
This command will shutdown the operating systems on your switch.
You are required to power-cycle the switch in order to restore operation.
Are you sure you want to shutdown the switch [y/n]? y
This is the active Cp
2005/11/16-05:47:20, [FSSM-1003], 5641,, WARNING, Brocade12000, HA State out
of sync
HA is disabled
Stopping blade 2
Shutting down the blade....
Stopping blade 8
Shutting down the blade....
Broadcast message from root (ttyS0) Wed Nov 16 05:47:20 2005...
The system is going down for system halt NOW !!
INIT: Switching to runlevel: 0
INIT: Sending processes the TERM signal
Unmounting all filesystems.
umount2: Device or resource busy
umount: /tmp: device is busy
The system is halted
flushing ide devices: hda
Power down.
ppc440gx System Halted
switch:admin> sysshutdown
Shut down the whole system is not support from the standby CP
For shut down the whole system
please run the sysshutdown from the active CP
Fabric OS Command Reference Manual
53-1000436-01