Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 43

ad--show and ad --validate may return incorrect information about switch port members for non-AD
--transabort
--transshow
Examples To enable AD5:
To enable AD_13:
To add new device members:
To apply all changes to the Admin Domain configurations (from the last time --apply was executed):
To clear all Admin Domain definitions:
To create an Admin Domain with a mix of D,PI, WWNs, and zone alias device members (two
different methods shown):
To create an Admin Domain with a switch list (specified using domain ID and switch WWN):
Fabric OS Command Reference Manual
53-1000436-01
FC Router Front Phantom Domain and FC Router Translate Phantom Domain
are virtual entities without any exposed management interfaces; hence, any
FC Router phantom switch WWNs specified in AD's switch memberlist will be
marked as non-Admin Domain aware members. All D,PI members in the
device list corresponding to an FC Router Phantom Domain will be marked as
non-Admin Domain aware members. All FC Router imported devices in the AD
device list will be marked as AD-aware members.
aware switches running pre-v3.2 Fabric OS. This is because pre-v3.2 Fabric
OS does not support Exchange Service Support (ESS), and therefore the
Name Server cannot get the correct port range of such switches.
Aborts the transaction buffer. ad --transabort prompts for confirmation before
aborting the transaction.
Displays the ID of the current Admin Domain transaction. It also provides
information about whether the transaction can be aborted. The transaction
cannot be aborted if it is an internal Admin Domain transaction.
switch:admin> ad --activate 5
You are about to activate a new admin domain.
Do you want to activate '5' admin domain (yes, y, no, n): [no] y
switch:admin> ad --activate AD_13
switch:admin> ad --add AD1, -d "100,5; 4,1"
switch:admin> ad --apply
You are about to enforce the saved AD configuration.
This action will trigger ad --apply to all switches in the fabric.
Do you want to apply all admin domains (yes, y, no, n): [no] y
switch:admin> ad --clear
You are about to delete all ADs definitions.
This operation will fail if zone configurations exists in AD1-AD254
Do you want to clear all admin domains (yes, y, no, n): [no] y
switch admin> ad --create "AD1", -d "100,5; 1,3; 20:00:00:e0:8b:05:4d:05"
switch admin> ad --create 1, -d "100,5; 1,3; 21:00:00:e0:8b:05:4d:05"
2
ad
11