Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 660

2
snmpConfig
FICON-TRAP
HA-TRAP
systemGroup Configuration Parameters
sysDescr
sysLocation
sysContact
authTraps
Operands This command supports following operands:
--show
--set
--default
--show, --set, and --default support the following:
snmpv1
snmpv3
accessControl
mibCapability
628
Specifying yes means the SNMP management application can receive FICON
traps from the switch. The default value is 'yes'. Users can also turn on or off
individual FICON Traps. The individual FICON Traps are
linkRNIDDeviceRegistration, linkRNIDDeviceDeRegistration,
linkLIRRListenerAdded, linkLIRRListenerRemoved and
linkRLIRFailureIncident.
Specifying yes means the SNMP management application can receive HA
traps from the switch. The default value is 'yes'. Users can also turn on or off
individual HA Traps. The individual HA Traps are fruStatusChanged,
cpStatusChanged, and fruHistoryTrap.
The system description. The default value is set as Fibre Channel Switch.
The location of the system (switch). The default value is set as End User
Premise.
The contact information for this system (switch). The default value is set as
Field Support. Refer to the definition of sysDescr, sysLocation and sysContact
in system group of MIB-II.
When enabled, the authentication trap (authenticationFailure) is transmitted
to a configured trap recipient in the event that the agent received a protocol
message that is not properly authenticated. In the context of SNMPv1 and
SNMPv2c, this means that a request contains a community string that is not
known to the agent. The default value for this parameter is 0 (disabled).
Displays the SNMP agent configuration data of the specified category.
Sets the SNMP agent configuration data of the specified category. This
operand displays the current settings and then prompts you to change the
values for each parameter.
Sets the SNMP agent configuration data for a specified item to the default
values. Generally, these default values might be available in the configuration
database. It sets to factory default settings if the SNMP agent configuration
parameters are not available in the configuration database.
Selects SNMPv1-related configuration parameters. SNMPv1 parameters
include the community string, trap recipient IP address, and trap severity
level associated with each trap recipient IP address.
Selects SNMPv3-related configuration parameters. SNMPv3 parameters
include user name, authentication protocol and password, SNMPv3 trap
recipients IP address, associated user index, and trap severity level.
Selects access-control-related parameters. accessControl parameters
include access host subnet area and access permission (read-write).
Selects configuration parameters related to the SNMP agent's MIBs and trap
capability parameters. mibCapability parameters include MIBs and traps
supported by the SNMP agent.
Fabric OS Command Reference Manual
53-1000436-01