Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 56

2
agtCfgDefault
Trap Recipient Severity Level
The trap severity level is associated with each trap recipient IP address. The event trap level is in
conjunction with the event's severity level. When an event occurs and if its severity level is at or
below the set value, the SNMP event traps (swEventTrap, swFabricWatchTrap, and
connUnitEventTrap) are sent to the trap recipients. By default, this value is set to 0, implying that no
such traps are sent. Possible values are:
0
1
2
3
4
5
Refer to errShow for related information.
The ACL check is as follows: there are six ACLs to restrict SNMP get/set/trap operations to hosts
under a host-subnet-area. Host-subnet-area is defined by comparing nonzero IP octets. For
example, an ACL of 192.168.64.0 enables access by any hosts that start with the specified octets.
The connecting host is enabled to set each host-subnet-area to be read-write or read-only. The
highest privilege matched out of six entries is given to the access. The ACL check is turned off when
all six entries contain 0.0.0.0. The default values of all six entries are 0.0.0.0.
When secure mode is enabled, the access control list feature is incorporated into the WSNMP and
RSNMP security policies. Community strings can be changed on the primary FCS switch only and
will propagate across the fabric.
Operands none
Examples To reset the SNMP agent to default values:
24
none
critical
error
warning
informational
debug
switch:admin> agtcfgdefault
*****
This command will reset the agent's configuration back to factory default
*****
Current SNMP Agent Configuration
Customizable MIB-II system variables:
sysDescr = Fibre Channel Switch.
sysLocation = End User Premise
sysContact = sweng
authTraps = 0 (OFF)
SNMPv1 community and trap recipient configuration:
Community 1: Secret C0de (rw)
Trap recipient: 192.168.15.41
Trap recipient Severity level: 4
Community 2: OrigEquipMfr (rw)
No trap recipient configured yet
Community 3: private (rw)
No trap recipient configured yet
Community 4: public (ro)
No trap recipient configured yet
Community 5: common (ro)
No trap recipient configured yet
Fabric OS Command Reference Manual
53-1000436-01