Brocade Communications Systems A7533A - Brocade 4Gb SAN Switch Base Command Reference Manual page 483

ipif -- IP interface entries.
Usage: portcfg ipif [slot/][ge]port option args.
iproute -- IP route entries.
Usage: portcfg iproute [slot/][ge]port option args.
rscnsupr -- Manages RSCN suppression on the local port.
Usage: portcfg rscnsupr [slot/][ge]port [-range] mode
Optional port configuration parameters for rscnsupr are:
Fabric OS Command Reference Manual
53-1000436-01
-r retransmissions
Specifies the maximum retransmissions for the existing tunnel.
retransmissions values are 1 to 16; default is 8. If tape pipelining is
enabled, default value is calculated based on the mininum retransmit time to
ensure that tcp connection does not timeout before the host times out. If
the user changes this value, the value specified must be greater than the
calculated value.
-s 0|1 Disable (0) or enable (1) selective acknowledgement (SACK) on the
existing tunnel.
-t 0|1 Disable (0) or enable (1) tape pipelining on turned on as well).
delete tunnel_id Deletes FCIP tunnel
Valid options and args for ipif are:
create ipaddr netmask mtu_size
Creates IP interfaces.
delete ipaddr netmask
Deletes IP interfaces.
Valid options and args for iproute are:
create ipaddr netmask gateway_router metric
Creates IP routes.
delete ipaddr netmask
Deletes IP routes.
An optional arg for rscnsupr is:
-range Specifies a range of ports in the same slot to apply the configuration to.
Valid modes for rscnsupr are:
--disable Disables the configuration. When disabled, device changes on the port
generates RSCN to another end device that is zoned with this one. By default,
RSCN suppression is disabled to all ports.
--enable Enables the configuration. When enabled, any device change on the port
does not generate RSCN to any other end device.
slot For bladed systems only, specifies the slot number of the port to be
configured, followed by a slash (/).
port Specifies the number of the ports to be configured, relative to its slot for
bladed systems. For GbE ports, the ports are numbered ge0 and ge1. Use
switchShow for a list of valid ports.
2
portCfg
451