Monitoring Flex Links And The Mac Address-Table Move Update - Cisco IE-3000-8TC Software Configuration Manual

Monitoring Flex Links and the MAC Address-Table Move Update

Command
Step 4
show mac address-table move update
Step 5
copy running-config startup config
To disable the MAC address-table move update feature, use the no mac address-table move update
receive configuration command. To display the MAC address-table move update information, use the
show mac address-table move update privileged EXEC command.
This example shows how to configure a switch to get and process MAC address-table move update
messages:
Switch# configure terminal
Switch(conf)# mac address-table move update receive
Switch(conf)# end
Monitoring Flex Links and the MAC Address-Table
Move Update
Table 22-1
MAC address-table move update information.
Table 22-1 Flex Links and MAC Address-Table Move Update Monitoring Commands
Command
show interfaces [interface-id] switchport
backup
show mac address-table move update
Cisco IE 3000 Switch Software Configuration Guide
22-14
Chapter 22
shows the privileged EXEC commands for monitoring the Flex Links configuration and the
Purpose
Displays the Flex Link backup interface configured for an interface or all the
configured Flex Links and the state of each active and backup interface (up
or standby mode). When VLAN load balancing is enabled, the output
displays the preferred VLANS on Active and Backup interfaces.
Displays the MAC address-table move update information on the switch.
Configuring Flex Links and the MAC Address-Table Move Update Feature
Purpose
Verify the configuration.
(Optional) Save your entries in the switch startup
configuration file.
OL-13018-03