Layer 3 Features - Cisco WS-CBS3032-DEL Software Configuration Manual

Features
•
•
•

Layer 3 Features

These are the Layer 3 features:
Some features noted in this section are available only in the IP services feature set.
Note
•
•
•
•
•
•
•
•
•
•
•
•
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
1-14
SRR as the scheduling service for specifying the rate at which packets are dequeued to the
–
egress interface (shaping or sharing is supported on egress queues). Shaped egress queues are
guaranteed but limited to using a share of port bandwidth. Shared egress queues are also
guaranteed a configured share of bandwidth, but can use more than the guarantee if other queues
become empty and do not use their share of the bandwidth.
Automatic quality of service (QoS) voice over IP (VoIP) enhancement for port -based trust of DSCP
and priority queuing for egress traffic
Full QoS support for IPv6 traffic
Auto-QoS enhancements that add automatic configuration classification of traffic flow from video
devices, such as the Cisco TelePresence System and Cisco Surveillance Camera.
HSRP Version 1 (HSRPv1) and HSRP Version 2 (HSRPv2) for Layer 3 router redundancy
HSRP for IPv6 (requires the IP services feature set)
IPv6 default router preference (DRP) for improving the ability of a host to select an appropriate
router.
IP routing protocols for load balancing and for constructing scalable, routed backbones:
RIP Versions 1 and 2
–
Full OSPF support (requires the IP services feature set)The IP Base image supports OSPF for
routed access to enable customers to extend Layer 3 routing capabilities to the access or wiring
closet.
HSRP for IPv6 (requires the IP services feature set)
–
Enhanced IGRP (EIGRP) (requires the IP services feature set)
–
Border Gateway Protocol (BGP) Version 4 (requires the IP services feature set)
–
IP routing between VLANs (inter-VLAN routing) for full Layer 3 routing between two or more
VLANs, allowing each VLAN to maintain its own autonomous data-link domain
Policy-based routing (PBR) for configuring defined policies for traffic flows
Multiple VPN routing/forwarding (multi-VRF) instances in customer edge devices to allow service
providers to support multiple virtual private networks (VPNs) and overlap IP addresses between
VPNs (requires the IP services feature set)
VRF Lite for configuring multiple private routing domains for network virtualization and virtual
private multicast networks
Support for these IP services, making them VRF aware so that they can operate on multiple routing
instances: HSRP, uRPF, ARP, SNMP, IP SLA, TFTP, FTP, syslog, traceroute, and ping
Fallback bridging for forwarding non-IP traffic between two or more VLANs (requires the IP
services feature set)
Static IP routing for manually building a routing table of network path information
Equal-cost routing for load-balancing and redundancy
Chapter 1 Overview
OL-13270-06