C H A P T E R 3 Assigning The Switch Ip Address And Default Gateway; Understanding The Boot Process - Cisco WS-CBS3032-DEL Software Configuration Manual

Understanding the Boot Process

Understanding the Boot Process
To start your switch, you need to follow the procedures in the hardware installation guide for installing
and powering on the switch and setting up the initial switch configuration (IP address, subnet mask,
default gateway, secret and Telnet passwords, and so forth).
The normal boot process involves the operation of the boot loader software, which performs these
activities:
•
•
•
•
The boot loader provides access to the flash file system before the operating system is loaded. Normally,
the boot loader is used only to load, uncompress, and start the operating system. After the boot loader
gives the operating system control of the CPU, the boot loader is not active until the next system reset
or power-on.
The boot loader also provides trap-door access into the system if the operating system has problems
serious enough that it cannot be used. The trap-door mechanism provides enough access to the system
so that if it is necessary, you can format the flash file system, reinstall the operating system software
image by using the Xmodem Protocol, recover from a lost or forgotten password, and finally restart the
operating system. For more information, see the
page 48-2
You can disable password recovery. For more information, see the
Note
section on page
Before you can assign switch information, make sure you have connected a PC or terminal to the console
port or a PC to the Ethernet management port, and make sure you have configured the PC or
terminal-emulation software baud rate and character format to match these of the switch console port:
•
•
•
•
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
3-2
Performs low-level CPU initialization. It initializes the CPU registers, which control where physical
memory is mapped, its quantity, its speed, and so forth.
Performs power-on self-test (POST) for the CPU subsystem. It tests the CPU DRAM and the portion
of the flash device that makes up the flash file system.
Initializes the flash file system on the system board.
Loads a default operating system software image into memory and boots up the switch.
and the "Recovering from a Lost or Forgotten Password" section on page
6-5.
Baud rate default is 9600.
Data bits default is 8.
If the data bits option is set to 8, set the parity option to none.
Note
Stop bits default is 1.
Parity settings default is none.
Chapter 3 Assigning the Switch IP Address and Default Gateway
"Recovering from a Software Failure" section on
"Disabling Password Recovery"
48-3.
OL-13270-06