Starting The Megaraid Webbios Utility On The Host Computer - LSI SCSI 320-0 Configuration

Starting the WebBIOS Utility on the Host Computer
When the host computer boots, hold the <Ctrl> key and press the <H> key when
the following appears:
Copyright© AMERICAN MEGATRENDS, INC.
Press <Ctrl><M> to Run Configuration Utility
Or press <Ctrl><H> for WebBIOS
After you press <Ctrl><H>, the Adapter Selection screen displays. You can use
this screen to select the adapter that you want to configure RAID arrays and
logical drives for. Select an adapter and press the Start button to begin the
configuration. If you want to use the BIOS configuration utility instead of
WebBIOS, click on the Control-M button.
Note: If there is a configuration mismatch between the disks and the NVRAM (Non-
volatile Random Access Memory) on the adapter, the Select Configuration
screen displays first. This screen is used to perform custom configuration, auto
configuration with redundancy, or auto configuration without redundancy. Auto
configuration with redundancy is recommended.
See page 46 for information about selecting a configuration, and page 53 for
information about configuration mismatches.
MegaRAID Configuration Software Guide
36