Installing And Registering Power Console Plus Components In A Netware Server 4.X - LSI SCSI 320-0 Configuration

Installing and Registering Power Console Plus Components in a
NetWare Server 4.x
TCP/IP must be configured and operational before you begin the following
procedure.
The process of installing the NetWare RAID and Registration
Server components overwrites RPCBSTUB.NLM in the
SYS:SYSTEM directory. In servers running Novell NetWare
4.1xs, this file is a Read-Only file, so you must first change the file
attribute to Read-Write before beginning installation.
Step
1 Insert the Power Console Plus installation disk in the floppy drive. From
the NetWare prompt, type:
LOAD X:RAIDINST.NLM (where X is the floppy drive letter)
and press <Enter> to load the following files:
RAIDSERV.NLM
REG_SERV.NLM
REG_MAIN.NLM
2 Select Install Package. If you are installing this package to a registration
server, select YES when prompted. If there is another server on the
network that is serving as the registration server, select NO. The files will
be copied to the Novell server.
3 Type the password when prompted. Verify the password when prompted.
Edit the Hosts File for a RAID Server Use the following procedure if installing Power Console
Plus on a server that is not a registration server.
Step
1 Type
LOAD EDIT
at the NetWare prompt and press <Enter>.
2 Press the <Ins> key and select SYS volume. Select the ETC directory.
Select the Hosts file and press <Enter>.
3 Add the TCP/IP address and name of the registration server.
MegaRAID Configuration Software Guide
96
Important
Action
Action
Cont'd