Adapter Properties - LSI SCSI 320-0 Configuration

Adapter Properties

The following screen appears when you select Adapter Properties from the
MegaRAID WebBIOS main screen:
The Adapter Properties menu options are:
Option
Firmware Version This item displays the firmware version number.
BIOS Version This item displays the BIOS version number.
RAM Size This item displays the size of the random access memory.
Initiator ID Identifying number for the MegaRAID card. You can change the Initiator ID
only when you are in cluster mode. You cannot change the ID while in
standard mode. The ID can be a number from 0 to 15. We recommend that
you use 6 or 7. When you are in standard mode, the ID is always 7.
Rebuild Rate Use this option to select the rebuild rate for drives attached to the selected
adapter.
Spinup Parameters Use this option to set the timing for spinning up the hard disk drives in the
computer. The options are Automatic, 2 per sec, 4 per sec, or 6 per sec.
Flex RAID Choose this option to enable or disable the FlexRAID PowerFail feature.
PowerFail This option allows drive reconstruction to continue when the system restarts
because of a power failure.
Alarm Control Choose this option to enable, disable, or silence the onboard alarm tone
generator.
Adapter BIOS Choose this option to enable or disable the BIOS on the adapter.
Cluster Mode Cluster mode allows the controller to operate as part of a cluster. You can
enable or disable cluster mode. When you disable cluster mode, the system
operates in standard mode. In addition, when you enable cluster mode, the
system automatically disables the BIOS.
Battery Backup Indicates whether the battery backup is present or absent.
Auto Rebuild Enable this option to automatically rebuild drives when they fail.
Class Emulation You can select this option to operate in I2O or mass storage mode.
Mode
Set Factory Enable this option to load the default MegaRAID WebBIOS Configuration
Defaults Utility settings.
Description
Chapter 3 WebBIOS Configuration Utility
39