Adding capacity under NetWare 4.x and 5.x,
Adding new space into the NetWare Volume
Step
1
Load INSTALL.NLM.
2
Highlight the VOLUME OPTIONS (configure, mount, or dismount
volumes).
3
Press <Enter>.
4
Press <Insert>.
5
Highlight the drive that has available space (it should be nearly 81 GB).
6
Press <Enter>.
7
Highlight the option Make Segment Part of Another Volume or New
Volume.
8
Press <Enter>.
9
Highlight the existing volume that you want to add to, if adding to an
existing volume.
10
Press <Enter>.
At this point, NetWare will show the rest of the free space of FlexRaid as
81GB.
11
Press <Enter> to modify the size of the new segment.
12
Under Disk Segment Parameters, type the size of the new drive to modify
the disk segment size.
13
After entering the size of the new drive(s), press <Enter>.
14
Press the F10 key.
15
Press the F10 key again (to save the new information.)
16
Press <Esc>.
17
Highlight Yes to save the changes.
18
Mount all the volumes.
Additional space is ready to be accessed without rebooting.
MegaRAID Configuration Software Guide
136
Continued
Action