Installing On A Windows Nt V4.X Server And Workstation87 - LSI SCSI 320-0 Configuration

Installing on a Windows NT V4.x Server and Workstation
Power Console Plus can be installed and registered on a Windows NT, Windows
2000. See the LSI Logic web site (www.lsilogic.com) for additional information
about supporting Novell NetWare as a RAID server. This allows the NetWare
server to be seen and accessed from Windows NT and 2000.
Installation Prerequisites Complete the following tasks before installing the Power Console Plus
software:
Step
1 Install the proper operating system software and service packs.
2 Install network cards in all computers that will need them.
3 Install a MegaRAID adapter card in the RAID server. Follow the procedures
in the appropriate MegaRAID Hardware Guide.
4 Install the TCP/IP Protocol on all specified systems.
5 The Power Console Plus installation process now prompts you to perform
the following edit. Edit the HOSTS file in c:\winnt\system32\drivers\etc. The
HOSTS file should look like this:
The HOSTS file information varies depending on the type of installation:
Example:
Specify all Sequential IP addresses for the server or servers, and the
workstation. For example:
Server A
Server B
Workstation C
All specified systems must conform to the TCP/IP specification for address
structures.
Press <Enter> after you type all names of the servers. If you do not,
Notepad might not enter the information.
6 Ping all systems by IP address and server name to make sure you have a
proper connection.
Action
Enter the IP address and name of all the MegaRAID servers,
including the registration server
123.123.234.1
123.123.234.2
123.123.234.3
Chapter 5 Installing Power Console Plus
87