LSI SCSI 320-0 Configuration page 125

Logical Drive Menu,
Check Consistency Choose this option to verify the redundancy data in logical drives that use
RAID levels 1, 3, or 5.
Select the drives to be checked and choose Check Consistency from the Logical
Drive menu. You are prompted to run parity checking. The following appears:
Parity Checking Selected Device(s)?
Click on OK to perform parity checking.
If a discrepancy is found, it is automatically corrected, assuming that the data is
correct. However, if the failure is a read error on a data drive, the bad data block
is reassigned with the generated data.
Choose Properties to display the properties of the selected logical drive. A
Properties
screen such as the following appears. Each logical drive can be displayed by
selecting the Previous or Next buttons.
Change Config The following appears when you select Change Config. You can change Cache
Policy, change Read Policy, change Write Policy, change the RAID level, select
a Virtual Size, and Add Capacity via this menu.
Note: The Enable Virtual Sizing feature will not take effect until the next
reboot. Virtual sizing is not supported in Windows 2000.
Continued
Chapter 6 Running Power Console Plus
Cont'd
117