Configuration Utility Check Consistency Menu
Check Consistency Choose this option to verify the redundancy data in logical drives that use
RAID levels 1, 3, or 5.
When you choose Check Consistency, the parameters of the existing logical
drives on the current controller and a selection menu listing the logical drives by
number appear. If a discrepancy is found, it is automatically corrected, assuming
always that the data is correct. However, if the failure is a read error on a data
drive, the bad data block is reassigned with the generated data.
Press the arrow keys to choose the desired logical drives. Press the spacebar to
select or deselect a drive for consistency checking. Press <F2> to select or
deselect all the logical drives.
Press <F10> to begin the consistency check. A progress indicator for each
selected logical drive is displayed.
When the consistency check is finished, press any key to clear the progress
display and press <Esc> to display the main menu.
Chapter 2 MegaRAID Configuration Utility
15