Classic Control Panel - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Classic Control Panel

Classic control panels can typically display two lines of 16 characters each.
As described in
menu allows you to enable or disable network protocols, and configure selected network parameters.
On the control panel display, an asterisk (*) is used to identify the selected value.
Table C-1 HP Jetdirect Classic Control Panel Menu
Menu Item
CFG NETWORK=
TCP/IP=
IPX/SPX=
DLC/LLC=
ATALK=
CFG TCP/IP=
164 Appendix C The HP Jetdirect EIO Control Panel Menu
Table C-1 HP Jetdirect Classic Control Panel
Description
Selects whether or not you want to access the Jetdirect menu.
NO (default): Bypass the HP Jetdirect menu.
YES: Access the HP Jetdirect menu. You must change this to YES* each time you want to
access the menu.
Identifies whether the protocol stack is enabled or disabled.
ON (default): The protocol is enabled.
OFF: The protocol is disabled.
Selects whether you want to access the TCP/IP menu and set TCP/IP protocol parameters.
NO (default): Bypass the TCP/IP menu items.
YES: Access the TCP/IP menu items.
■ BOOTP=YES* enables IPv4 configuration by a BootP Server.
■
DHCP=YES* enables IPv4 configuration by a DHCP Server.
If DHCP=YES* and the print server has a DHCP lease, you can choose to configure the
following DHCP settings:
■ RELEASE: Choose YES to release, or NO to save, the current DHCP lease.
■ RENEW: Choose YES to renew the current DHCP lease, or NO to not renew the
DHCP lease.
■ AUTO IP=YES* will automatically assign a link-local IPv4 address in the form 169.254.x.x.
Menu, the HP Jetdirect control panel
ENWW