Resetting To Factory Defaults; Service Menu Example - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Resetting to Factory Defaults

Parameters on the HP Jetdirect print server (for example, the IP address) can be reset to factory
default values using the following procedures:
CAUTION
values. However, a Certificate Authority (CA) certificate installed to validate a network
authentication server will not be saved.
■ HP LaserJet Printer with Internal EIO Print Server
In most cases, the HP Jetdirect internal print server can be reset to factory defaults when a cold-
reset is performed on the printer.
CAUTION
Resetting the printer will clear all data from the printer memory and reset all printer
settings, including network configurations, to their factory default values. After a cold
reset, users may be affected due to changes in user-specified printer settings. Network
systems may lose their connection to the printer.
NOTE
not reset the HP Jetdirect print server.
■ For older HP LaserJet printers, a cold-reset is performed by power cycling the printer while
pressing the Go, Start, or Pause/Resume button.
■ For recent LaserJet printers and MFPs, use the printer's Service menu accessed during the
initial power-on sequence. See
■ For other printers, refer to your printer manuals. Or, visit
search for document file bpj02300.html.
NOTE
values have been assigned.

Service Menu Example

To perform a cold reset on many recent HP LaserJet printers and MFPs:
1 Turn the printer on and watch for the memory count to begin.
2
Press and hold the Select
the three control panel lights (Ready, Data, Attention) blink and then remain on.
3
Release the Select
4
Press the down arrow
5
Press the Select
sequence.
112 Chapter 7 Troubleshooting the HP Jetdirect Print Server
A Jetdirect X.509 certificate will be saved over a cold reset to factory default
Be sure to print a Jetdirect configuration page before performing a cold reset.
The Restore Factory Settings menu item in the printer control panel menu will
Service Menu
After a cold reset, print a Jetdirect configuration page to confirm that factory-reset

button (or the "6" button on MFPs with numeric keypads only) until

button (or "6" button). The control panel will display Select Language.
M
button (or "9" button) until Cold Reset appears.

button (or "6" button) to perform a cold reset and then continue its power-on
Example.
http://www.hp.com/go/support and
ENWW