Ipsec; Network Statistics; Protocol Info; Configuration Page - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Table 4-17 802.1X Configuration Settings (continued)
Item
Encryption Strength
CA Certificate
Authentication Behavior:
Reauthenticate on Apply
Restore Defaults

IPsec

Use this page to configure and view the IPsec (Internet Protocol security) policy for the print server.
You can enable or disable IPsec operation on the print server, and configure the default rule for non-
IPsec packets:
■ to allow all non-IPsec traffic for which IPsec rules do not apply, or
■ to discard (drop) all non-IPsec traffic.
Rules that define the IPsec policy are configured through an IPsec wizard, which is run when you
click Add Rule. For more information, see

Network Statistics

This page is used to display counter values and other status information currently stored on the HP
Jetdirect print server. This information is often useful to diagnose performance and operational
problems associated with the network or network device.

Protocol Info

This page provides a list of various network configuration settings on the HP Jetdirect print server for
each protocol. Use these lists to validate your desired settings.

Configuration Page

This page provides a view of the HP Jetdirect configuration page that contains a summary of HP
Jetdirect status and configuration information. The contents of this page are described in
Jetdirect Configuration
94 Chapter 4 HP Jetdirect Embedded Web Server (V.31.xx)
Description
Specify the minimum encryption strength that can be used during communications with
the authentication server. You may select Low, Medium, or High encryption strength.
For each encryption strength, ciphers are specified to identify the weakest cipher
allowed.
To validate the authentication server's identity, the authentication server's certificate or
a CA (or "Root") certificate must be installed on the print server. This CA certificate must
be issued by the Certificate Authority who signed the authentication server's certificate.
To configure or install a CA certificate, click Configure.
Enable (check) or disable (clear) this checkbox to control authentication when you click
Apply on this page, assuming valid configuration entries have been made.
NOTE This parameter does not apply to security or other configuration
wizards. Changes to parameters through a wizard will always cause the print
server to reauthenticate.
If disabled (default), the print server will not attempt reauthentication unless
configuration changes cause the print server to disconnect and reconnect to the network.
If enabled, the print server will always try to reauthenticate using the configuration
values set.
Click this button to restore 802.1X configuration settings to factory default values.
IPsec
Pages.
Configuration.
HP
ENWW