HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 146

Table 8-12 Error Messages (continued)
Error Code and Message
4E CF ERR - TRAP LIST
EXCEEDED
4F TFTP REMOTE ERROR
50 TFTP LOCAL ERROR
51 TFTP RETRIES EXCEEDED
52 BAD BOOTP/DHCP REPLY
53 BAD BOOTP TAG SIZE
54 BOOTP/RARP IN PROGRESS
55 BOOTP/DHCP IN PROGRESS
56 DHCP NAK
57 UNABLE TO CONNECT DHCP
SVR
58 POSTSCRIPT MODE NOT
SELECTED
59 INCOMPLETE F/W - MUST
DOWNLOAD
5A TURN PRINTER OFF / ON
5C DHCP BAD REPLY
5D DHCP LEASE DURATION TOO
SHORT
5E DHCP LEASE RELEASED
5F WINS REGISTRATION FAILED
61 AUTO IP CONFIGURED
136 Chapter 8 HP Jetdirect Configuration Pages
Description
The TFTP configuration file specified too many trap destination list entries using the
"trap-destination:" keyword.
The TFTP transfer of the configuration file from the host to the HP Jetdirect print
server failed with the remote host sending a TFTP ERROR packet to the print server.
The TFTP transfer of the configuration file from the host to the HP Jetdirect print
server failed with the local print server encountering some form of inactivity timeout,
or excessive retransmissions situation.
The overall retrying of the TFTP transfer of the configuration file from the host to the
HP Jetdirect print server has exceeded a retry limit.
An error was detected in the BOOTP or DHCP reply that the HP Jetdirect print server
received. The reply either had insufficient data in the UDP datagram to contain the
minimum BOOTP/DHCP header of 236 bytes, had an operation field that was not
BOOTPREPLY(0X02), had a header field that did not match the print servers
hardware address, or had a UDP source port that was not the BOOTP/DHCP server
port (67/udp).
The tagsize in a vendor-specific field in the BOOTP reply is either 0, or greater than
the remaining number of unprocessed bytes in the vendor-specified area.
The HP Jetdirect print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/RARP.
The HP Jetdirect print server is currently in the process of obtaining its basic IP
configuration information through BOOTP/DHCP, and has not detected any errors.
The HP Jetdirect print server received a negative acknowledgement message from
the DHCP server in response to a configuration request.
The HP Jetdirect print server had received IP parameters from a DHCP server, but
communication with the DHCP server has been lost. Check status of the DHCP
server.
If an infinite lease was assigned, the print server will use the IP address of the most
recent DHCP server used, but operation may be degraded until a DHCP server
responds.
The printer does not support AppleTalk or AppleTalk extensions.
Firmware download message. Currently downloading firmware to the HP Jetdirect
print server, or the download did not complete properly.
Firmware download message. Download of firmware is complete. Power off/on the
HP Jetdirect print server.
A bad reply was received from the DHCP server. Check your DHCP server settings
for this print server.
The DHCP lease times for this print server's TCP/IP configuration settings are too
short. Reconfigure the DHCP lease times on the DHCP server.
The lease for DHCP-configured parameters, including the IP address, have been
released through a manual configuration method, such as through the printer's
control panel.
Attempts to register the print server's name on the WINS server failed. Check for
duplicate names, or verify the WINS server configuration.
An IP address could not be retrieved over the network. The print server will default to
an IP address using link-local addressing in the form 169.254.x.x.
ENWW