HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 181

Table C-2 HP Jetdirect Graphical Control Panel Menu (continued)
Menu Item
LINK SPEED
PRINT
PROTOCOLS
ENWW
Submenu Options Additional Options
IPSEC
RESET SECURITY
AUTO
10T HALF
10T FULL
100TX HALF
100TX FULL
100TX AUTO
1000 FULL
Description of settings
HTTPS REQUIRED: For secure, encrypted
communications, only HTTPS access is accepted. The
print server will appear as a secure site.
HTTPS OPTIONAL: Access using either HTTP or
HTTPS is permitted.
Specify the operation of IPsec on the print server.
KEEP: IPsec status will remain the same as currently
configured.
DISABLE: IPsec operation on the print server will be
disabled.
Specify whether the current security settings on the
print server will be saved or reset to factory defaults.
NO (default): The current security settings are
maintained.
YES: Security settings are reset to factory defaults.
The link speed and communication mode of the print
server must match the network. The available settings
depend on the print server model. One of the following
link configuration settings can be selected:
CAUTION If you change the link setting,
network communications with the print server
and network device may be lost.
AUTO (default): The print server uses auto-negotiation
to configure itself with the highest link speed and
communication mode allowed. If auto-negotiation fails,
either 100TX HALF or 10TX HALF is set depending on
the detected link speed of the hub/switch port. (A
1000T half-duplex selection is not supported.)
10T HALF: 10 Mbps, half-duplex operation.
10T FULL: 10 Mbps, Full-duplex operation.
100TX HALF: 100 Mbps, half-duplex operation.
100TX FULL: 100 Mbps, full-duplex operation.
100TX AUTO: Limits auto-negotiation to a maximum
link speed of 100 Mbps.
1000 FULL: 1000 Mbps, full-duplex operation.
Use this item to print a page containing the
configuration of the following protocols: IPX/SPX,
Novell NetWare, AppleTalk, DLC/LLC.
Graphical Control Panel 171