HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 149

Table 8-13 Security Settings (continued)
Message
Admin Password:
Cert Expires:
SNMP Versions:
SNMP Set Cmty Name:
Access List:
ENWW
Description
Policy Failed: The print server failed to implement the IPsec policy that was
configured. You may need to reset security (through the control panel or embedded
Web server), or perform a cold-reset of the print server.
Specifies whether an IP Administrator password has been configured on the print
server. This password is shared by Telnet, the embedded Web server, and HP Web
Jetadmin to control access to print server configuration parameters. Up to 16 case-
sensitive, alphanumeric characters can be used.
Not Specified: An Administrator password has not been set.
Set: An Administrator password has been set.
(The password may be cleared from the print server through a cold reset.)
Specifies the expiration date of the digital certificate for SSL/TLS encrypted security.
The date is in UTC format (for example, "2002-10-02 12:45 UTC").
Not Applicable: Displayed if a digital certificate has not been installed.
Specifies the SNMP versions enabled on the print server.
Disabled: All SNMP versions are disabled on the print server. No SNMP access is
allowed.
1;2: SNMP v.1 and SNMP v.2c are supported, and SNMP v.3 is disabled, or not
supported.
1;2;3-na/np: SNMP v.1, v.2c, and v.3 are enabled. v.3 is enabled with the minimum
security of no authentication ("na") and no privacy ("np").
1;2;3-a/np: SNMP v.1, v.2c, and v.3 are enabled. v.3 is enabled with the minimum
security of authentication enabled ("a") but no privacy ("np").
1;2;3-a/p: SNMP v.1, v.2c, and v.3 are enabled. v.3 is enabled with the minimum
security of authentication ("a") with privacy ("p") enabled.
3-na/np: SNMP v.1 and v.2c are disabled. SNMP v.3 is enabled with the minimum
security of no authentication ("na") and no privacy ("np").
3-a/np: SNMP v.1 and v.2c are disabled. SNMP v.3 is enabled with the minimum
security of authentication enabled ("a") but no privacy ("np").
3-a/p: SNMP v.1 and v.2c are disabled. SNMP v.3 is enabled with the minimum
security of authentication ("a") with privacy ("p") enabled.
Specifies whether an SNMP set community name has been configured on the HP
Jetdirect print server. An SNMP set community name is a password for write access
to SNMP control functions (SNMP SetRequests) on the HP Jetdirect print server.
Not Specified: An SNMP set community name has not been set.
Specified: A user-specified SNMP set community has been set.
(IPv4 only) Identifies whether a host access control list is configured on the HP
Jetdirect print server. A host access control list specifies the IP address of individual
systems, or IP network of systems, that are allowed access to the print server and
device.
Specified: A host access list is configured on the HP Jetdirect print server.
Not Specified: A host access list is not configured on the print server. All systems are
allowed access.
Security Configuration Page 139