HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 133

Table 8-3 Security Settings
Message
802.1X
IPsec:
Admin Password:
Cert Expires:
SNMP Versions:
SNMP Set Cmty Name:
ENWW
Description
Identifies whether the print server has been configured with EAP/802.1X client
authentication settings.
Specified: 802.1X authentication has been configured.
Not Specified: 802.1X authentication has not been configured.
Provides the print server's current IPsec status.
Enabled: IPsec is enabled and operating as configured by the user.
Disabled: IPsec is turned off.
Policy Failed: The print server failed to implement the IPsec policy that was
configured. You may need to reset security (through the control panel or embedded
Web server), or perform a cold-reset of the print server.
Specifies whether an IP Administrator password has been configured on the print
server. This password is shared by Telnet, the embedded Web server, and HP Web
Jetadmin to control access to print server configuration parameters. Up to 16 case-
sensitive, alphanumeric characters can be used.
Not Specified: An Administrator password has not been set.
Set: An Administrator password has been set.
(The password may be cleared from the print server through a cold reset.)
Specifies the expiration date of the digital certificate for SSL/TLS encrypted security.
The date is in UTC format (for example, "2002-10-02 12:45 UTC").
Not Applicable: Displayed if a digital certificate has not been installed.
Specifies the SNMP versions enabled on the print server.
Disabled: All SNMP versions are disabled on the print server. No SNMP access is
allowed.
1;2: SNMP v.1 and SNMP v.2c are supported, and SNMP v.3 is disabled, or not
supported.
1;2;3-na/np: SNMP v.1, v.2c, and v.3 are enabled. v.3 is enabled with the minimum
security of no authentication ("na") and no privacy ("np").
1;2;3-a/np: SNMP v.1, v.2c, and v.3 are enabled. v.3 is enabled with the minimum
security of authentication enabled ("a") but no privacy ("np").
1;2;3-a/p: SNMP v.1, v.2c, and v.3 are enabled. v.3 is enabled with the minimum
security of authentication ("a") with privacy ("p") enabled.
3-na/np: SNMP v.1 and v.2c are disabled. SNMP v.3 is enabled with the minimum
security of no authentication ("na") and no privacy ("np").
3-a/np: SNMP v.1 and v.2c are disabled. SNMP v.3 is enabled with the minimum
security of authentication enabled ("a") but no privacy ("np").
3-a/p: SNMP v.1 and v.2c are disabled. SNMP v.3 is enabled with the minimum
security of authentication ("a") with privacy ("p") enabled.
Specifies whether an SNMP set community name has been configured on the HP
Jetdirect print server. An SNMP set community name is a password for write access
to SNMP control functions (SNMP SetRequests) on the HP Jetdirect print server.
HP Jetdirect Configuration Page 123