Table 8-12
Error Messages (continued)
Error Code and Message
3A NDS ERR: UNABLE TO FIND
TREE
3B NDS CONNECTION STATE
ERROR
3C NDS ERR: UNRESOLVED
QUEUE
3D NDS ERR: CANNOT READ Q
HOST
3E NDS PRNT SRVR PUBLIC KEY
ERR
3F UNABLE TO GET NDS SRVR
ADDR
40 ARP DUPLICATE IP ADDRESS
41 NOVRAM ERROR
42 INVALID IP ADDRESS
43 INVALID SUBNET MASK
44 INVALID GATEWAY ADDRESS
45 INVALID SYSLOG ADDRESS
46 INVALID SERVER ADDRESS
47 INVALID TRAP DEST ADDRESS One of the SNMP trap (Trap PDU) destination IP addresses specified for the HP
48 CF ERR - FILE INCOMPLETE
49 CF ERR - LINE TOO LONG
4A CF ERR - UNKNOWN
KEYWORD
4B CF ERR - MISSING
PARAMETER
4C CF ERR - INVALID PARAMETER A line in the TFTP configuration file contained an invalid value for one of the
4D CF ERR - ACCESS LIST
EXCEEDED
ENWW
Description
The NDS tree cannot be located. The message may occur when the file server is not
running or when a network communications problem exists.
The HP Jetdirect print server cannot change the NDS connection state. Check
licenses on the spooling server.
The print queue object cannot be located in the specified NDS context.
Cannot locate the file server on the network. The server may not be running at this
time or a communications problem may exist.
Print Server Object Name mismatch. Unable to read the print server's public key.
Verify object names. Verify that the object key assigned to the HP Jetdirect print
server is a print server object and not a printer or other object.
The NDS server address cannot be located or accessed.
The ARP layer has detected another node on the network using the same IP address
as the HP Jetdirect print server. Extended error information below this message
shows the hardware address of the other node.
The HP Jetdirect print server cannot read the contents of its NOVRAM.
The IP address specified for the HP Jetdirect print server (through BOOTP) is an
invalid IP address for specifying a single node. Check your Bootptab file for proper
entries.
The IP subnet mask specified for the HP Jetdirect print server (through BOOTP) is
an invalid subnet mask. Check your Bootptab file for proper entries.
The default gateway IP address specified for the HP Jetdirect print server (through
BOOTP) is an invalid IP address for specifying a single node. Check your Bootptab
file for proper entries.
The syslog server IP address specified for the HP Jetdirect print server (through
BOOTP) is an invalid IP address for specifying a single node. Check your Bootptab
file for proper entries.
The TFTP server IP address specified for the HP Jetdirect print server (through
BOOTP) is an invalid IP address for specifying a single node. Check your Bootptab
file for proper entries.
Jetdirect print server (through TFTP) is an invalid IP address for specifying a single
node. Check your TFTP configuration file.
The TFTP configuration file contained an incomplete last line that did not end in a
newline character.
A line being processed in the TFTP configuration file was longer than the HP
Jetdirect print server could accept.
A TFTP configuration file line contained an unknown keyword.
A line in the TFTP configuration file was missing a required parameter.
parameters on that line.
The TFTP configuration file specified too many access list entries using the "allow:"
keyword.
HP Jetdirect Configuration Page
135
Need help?
Do you have a question about the 635n - JetDirect IPv6/IPsec Print Server and is the answer not in the manual?
Questions and answers