Advanced - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Table 4-7 TCP/IP Config Precedence tab (continued)
Item
Reinitialize Now
Clear Previous Values and
Reinitialize Now
Apply
Cancel
Example: To set all parameters configured through DHCP to be "Read-only", and to allow manual
configuration only of parameters that are not configured through DHCP, proceed as follows:
1 Power on the print server so that it obtains its DHCP configuration.
2 Change the precedence table to the following:
BOOTP/DHCPv4
DHCPv6
TFTP
Manual
Default
3 Press Clear Previous Values and Reinitialize Now

Advanced

This tab provides configuration of additional TCP/IP parameters described below.
Table 4-8 TCP/IP Advanced tab
Item
Idle Timeout
Banner Page
System Contact
ENWW
Description
This button saves the new precedence table, clears the configuration method to its
factory-default setting, and restarts the IP stack.
This button saves the new precedence table, clears the configuration method to its
factory-default setting, clears current TCP/IP parameter settings, and restarts the IP
stack.
The Apply button saves changes to the Configuration Methods precedence table.
Depending on the changes made, you may need to turn the print server Off/On to
implement the change.
The Cancel button cancels your changes to the precedence table.
CAUTION The Cancel button will not affect changes made by the
Reinitialize Now or Clear Previous Values and Reinitialize Now buttons.
Description
(IPv4 or IPv6) Specifies the number of seconds that an idle connection is allowed to
remain open. Up to 3600 seconds can be set. 270 is the default value. If set to 0, the
timeout is disabled and TCP/IP connections will remain open until closed by the
device at the other end of the network (for example, a workstation).
(IPv4 or IPv6) Specifies whether to enable or disable printing of an LPD banner page
for print jobs. For currently supported print servers, only a single port is available
(Port 1).
(IPv4 or IPv6) Identifies a person who is assigned to administer or service this
device. This field may include a phone number or similar information.
When configured, this parameter will be displayed on the HP Jetdirect home page.
Networking Tab 73