Moving To Another Network (Ipv4); Using The Embedded Web Server; Using The Printer Control Panel - HP Jetdirect J7974E Administrator's Manual

NOTE
Parameters for other subsystems such as IPX/SPX or AppleTalk are not affected.
To reset all parameters to factory default values, refer to
Server.

Moving to Another Network (IPv4)

When moving an HP Jetdirect print server that is configured with an IP address to a new network, make
sure that the IP address does not conflict with addresses on the new network. You may change the IP
address of the print server to one that can be used on the new network, or erase the current IP address
and configure another address after it is installed on the new network. See
Jetdirect Print Server
If the current BOOTP server is not reachable, you may need to locate a different BOOTP server and
configure the printer to this server.
If the print server was configured using BOOTP, DHCP or RARP, edit the appropriate system files with
updated settings. If the IP address was manually set (for example, from the printer control panel or
Telnet), reconfigure IP parameters as described in this chapter.

Using the Embedded Web Server

You can use the embedded Web server on the HP Jetdirect print server to configure or view IPv4 and
IPv6 parameters. For more information, refer to

Using the Printer Control Panel

When supported by the printer, HP Jetdirect print servers provide a configuration menu that can be
accessed from the printer's control panel. Using this menu, you can enable or disable network protocols
and set basic network parameters.
NOTE
documentation.
Depending on the HP Jetdirect print server and printer, configuration of selected IPv4/IPv6 and
IPsec networking parameters through the control panel is supported.
When accessing the HP Jetdirect menu from the printer's control panel, some TCP/IP network
configuration parameters that you can set include the following (see
Menu (V.34.xx)
●
IP host name
●
TCP/IPv4 settings
●
TCP/IPv6 settings
●
Other network protocols (IPX/SPX, AppleTalk, DLC/LLC)
●
Security settings
●
Link configuration settings
56 Chapter 3 TCP/IP Configuration
This procedure resets all TCP/IP parameters, but only affects the TCP/IP subsystem.
for instructions to reset the print server to factory default settings.
For instructions on using the control panel for your printer, refer to your printer
for additional parameters):
Troubleshooting the HP Jetdirect Print
HP Jetdirect Embedded Web Server
The HP Jetdirect Control Panel
Troubleshooting the HP
(V.34.xx).
ENWW