HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 62

Table 3-3 Telnet Commands and Parameters (continued)
dhcp-fqdn-config
(dhcp-fqdn-behavior)
duid
dns-cache-ttl
dhcp-arbitration
phone-home-config
TCP/IP Diagnostics
Last Config IP
TCP Conns Refused
TCP Access Denied
DHCP Lease Time
DHCP Renew Time
DHCP Rebind Time
SNMP
snmp-config
52 Chapter 3 TCP/IP Configuration
Specifies configuration control of the Fully Qualified Domain Name (FQDN), using either
DHCP, manual configuration, or both. The fully qualified domain name consists of the
device's host name and domain name. Select one of the following command values:
0 (default): DHCP may be used to supply the host name and domain name. The host
name may be changed using a manual configuration method (such as the embedded
Web server, printer control panel, or Telnet). However, the domain name cannot be
manually changed if it was configured through DHCP.
1: Keep DHCP settings only. Once the Fully Qualified Domain Name is configured
through DHCP, manual changes cannot be made.
2: Keep manual settings. The settings can be manually configured. DHCP may be used
only if the settings are factory-default values.
3: Keep manual settings only. While manual configuration methods may be used,
configuration through DHCP is not allowed.
Specifies the DHCP Unique Identifier for a client, using a hexadecimal string to
represent up to 260 characters.
The time-to-live for a cached DNS name, in seconds. Specify a value from 0 to
4294967295 seconds. If 0, names will not be cached.
Specifies the amount of time, in seconds, that the print server will wait for DHCP
configuration offers. A value from 1 to 10 may be set. The default is 5 seconds.
Specifies privacy settings on the print server during embedded Web server access. This
command controls whether statistical data on product use may be sent to HP. For HP to
collect data, Internet access is required.
2: Prompt the user to allow sending data on initial access to the Networking tab of the
embedded Web server. This is the factory-default and cold-reset value. Once changed,
this value cannot be re-selected.
1: Allows the sending of data to HP without prompting the user.
0: Disables sending data to HP without prompting the user.
(Read-only parameter) The IP address of the system from which the HP Jetdirect print
server's IP address was configured.
(Read-only parameter) The number of client TCP connections that are refused by the
print server.
(Read-only parameter) The number of times that client systems were denied access to
the print server because there was no allowable entry in the print server's host access
list.
(Read-only parameter) DHCP IP address lease duration time (seconds).
(Read-only parameter) DHCP T1 timeout, specifying the DHCP lease renewal time
(seconds).
(Read-only parameter) DHCP T2 timeout, specifying the DHCP lease rebind time
(seconds).
Enables or disables SNMP operation on the print server. 0 disables, 1 (default) enables
SNMP.
ENWW