HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 175

Table C-1 HP Jetdirect Classic Control Panel Menu (continued)
Menu Item
CFG IPX/SPX=
WEB=
ENWW
Description
If you specify BOOTP=NO*, DHCP=NO* and AUTO IP=NO*, you can manually set the
following TCP/IPv4 parameters from the control panel:
■ Each byte of the IPv4 address (IP)
■ Subnet Mask (SM)
■ Syslog Server (LG)
■ Default Gateway (GW)
■ Idle Timeout period (default is 270 seconds, 0 disables the timeout)
■ CFG DNS 1=YES* will allow you to specify the IPv4 address of a primary DNS server,
one byte at a time.
■ CFG DNS 2=YES* will allow you to specify the IPv4 address of a secondary DNS server,
one byte at a time.
■ IPV6 = YES* enables IPv6 operation on the print server. Select NO to disable IPv6
operation.
■ POLICY=<option> allows you to select one of the following IPv6 addressing policies for
the print server.
■ RTR_AV: (default) The stateful auto-configuration method to be used by the print
server is determined by a router. The router specifies whether or not the print server
is to obtain its address, its configuration information, or both from a DHCPv6 server.
■ RTR_UN: If a router is not available, the print server should attempt to obtain its
stateful configuration from a DHCPv6 server.
■ ALWAYS: Whether or not a router is available, the print server will always attempt to
obtain its stateful configuration from a DHCPv6 server.
■ MANUAL=<option> specifies the behavior for a manually-configured IPv6 address
detected on the print server.
■ KEEP: (default) If configured, maintain the address in an active state.
■ DISABLE: If configured, maintain the address but in an inactive state.
Print a Jetdirect configuration page to verify your settings. However, note that the print server
may overwrite selected parameters with values that ensure proper operation.
Selects whether you want to access the IPX/SPX menu and set IPX/SPX protocol parameters.
NO (default): Bypass the IPX/SPX menu items.
YES: Access the IPX/SPX menu items.
In the IPX/SPX menu, you can specify the Frame Type parameter used on your network.
■ AUTO (default) will automatically set and limit the frame type to the first one detected.
■ For Ethernet cards, frame type selections include EN_8023, EN_II, EN_8022, EN_SNAP.
For configuration management, specify whether the embedded Web server will accept
communications using HTTPS (Secure HTTP) only, or both HTTP and HTTPS.
HTTPS: For secure, encrypted communications, only HTTPS access is accepted. The print
server will appear as a secure site.
HTTP/HTTPS: Access using either HTTP or HTTPS is permitted.
Classic Control Panel 165