HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 64

Table 3-3 Telnet Commands and Parameters (continued)
ipx-frametype
ipx-sapinterval
ipx-mode
ipx-nds-tree
ipx-nds-context
ipx-job-poll
pjl-banner
(ipx-banner)
pjl-eoj
(ipx-eoj)
pjl-toner-low
(ipx-toner-low)
AppleTalk
appletalk
Name
Print Type
Zone
Phase
Status
DLC/LLC
dlc/llc-config
54 Chapter 3 TCP/IP Configuration
Specifies the IPX frame type settings available for your print server model: AUTO
(default), EN_SNAP, EN_8022, EN_8023, EN_II. For more information, see
Jetdirect Configuration Pages.
Specifies the time interval (1 to 3600 seconds) that the HP Jetdirect print server waits
between Service Advertising Protocol (SAP) broadcasts on the network. The default is
60 seconds. 0 disables SAP broadcasts.
(Read-only parameter) Specifies the NetWare mode configured on the print server,
either RPRINTER or QSERVER mode.
An alphanumeric string, up to 31 characters, that specifies the NDS tree name for the
print server.
An alphanumeric string, up to 256 characters, that specifies the NDS context for the HP
Jetdirect print server.
Specifies the time interval (1 to 255 seconds) that the HP Jetdirect print server will wait
to check for print jobs in a print queue. The default is 2 seconds.
Enables or disables printing an IPX banner page through Printer Job Language (PJL). 0
disables banner pages. 1 (default) enables banner pages.
Enables or disables IPX end-of-job notification through PJL. 0 disables, 1 (default)
enables.
Enables or disables IPX toner-low notification through PJL. 0 disables, 1 (default)
enables.
Enables or disables AppleTalk (EtherTalk) protocol operation on the print server. 0
disables, 1 (default) enables. For example,
appletalk 0 will disable AppleTalk operation
(Read-only parameter) The name of the printer on the AppleTalk network. A number
after the name indicates that there are multiple devices with this name, and this is the
Nth instance of the name.
(Read-only parameter) Specifies the AppleTalk network printer type reported by the
Jetdirect print server. Up to three print types may be reported.
(Read-only parameter) The name of the AppleTalk network zone on which the printer is
located.
(Read-only parameter) AppleTalk phase 2 (P2) is preconfigured on the HP Jetdirect
print server.
(Read-only parameter) Indicates the current AppleTalk configuration status.
READY: Indicates the HP Jetdirect print server is awaiting data.
DISABLED: Indicates that AppleTalk was manually disabled.
INITIALIZING: Indicates that the print server is registering the node address or name.
An additional status message may also be displayed.
Enables or disables DLC/LLC protocol operation on the print server. 0 disables, 1
(default) enables. For example,
dlc/llc-config 0 will disable DLC/LLC operation.
HP
ENWW