HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 178

Table C-2 HP Jetdirect Graphical Control Panel Menu (continued)
Menu Item
168 Appendix C The HP Jetdirect EIO Control Panel Menu
Submenu Options Additional Options
DHCP RENEW
MANUAL
SETTINGS
DEFAULT IP
PRIMARY DNS
SECONDARY DNS
IPV6 SETTINGS ENABLE
ADDRESS
Description of settings
This menu appears if CONFIG METHOD was set to
DHCP and a DHCP lease for the print server exists.
■ NO (default): The print server does not request to
renew the DHCP lease.
■ YES: The print server requests to renew the
current DHCP lease.
(Available only if CONFIG METHOD is set to
MANUAL) Configure parameters directly from the
printer control panel:
■ IP ADDRESS n.n.n.n: The unique IP address of
the printer, where n is a value from 0 to 255.
■ SUBNET MASK m.m.m.m: The subnet mask for
the printer, where m is a value from 0 to 255.
■ SYSLOG SERVER n.n.n.n: The IP address of the
syslog server used to receive and log syslog
messages.
■ DEFAULT GATEWAY n.n.n.n: The IP address of
the gateway or router used for communications
with other networks.
■ IDLE TIMEOUT: The time period, in seconds, after
which an idle TCP print data connection is closed
(default is 270 seconds, 0 disables the timeout).
Specify the IP address to default to when the print
server is unable to obtain an IP address from the
network during a forced TCP/IP reconfiguration (for
example, when manually configured to use BootP or
DHCP).
■ AUTO IP: A link-local IP address 169.254.x.x will
be set.
■ LEGACY: The address 192.0.0.192 will be set,
consistent with older Jetdirect products.
Specify the IP address (n.n.n.n) of a Primary DNS
Server.
Specify the IP address (n.n.n.n) of a Secondary
Domain Name System (DNS) Server.
Use this item to enable or disable IPv6 operation on
the print server.
ON: IPv6 will be enabled.
OFF: IPv6 will be disabled.
Use this item to manually configure an IPv6 address.
MANUAL SETTINGS: Use the MANUAL SETTINGS
menu (see the additional options under IPV6
ENWW