HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 55

Jetdirect print servers
Hide thumbs Also See for 635n - JetDirect IPv6/IPsec Print Server:
Table of Contents

Advertisement

Command Line Interface (Default)
Using the Telnet command line interface, you can set configuration parameters using the following
procedures:
NOTE
correct command format, and a list of commands.
To list additional (or advanced) commands, enter the command advanced before entering ?.
To display current configuration information, enter /.
1
At the Telnet prompt ">" type:
<parameter>: <value>
then press Enter, where <parameter> refers to the configuration parameter you are defining,
and <value> refers to the definitions you are assigning to that parameter. Each parameter entry
is followed by a carriage return.
See
Table 3-3 Telnet Commands and Parameters
2
Repeat the previous step to set any additional configuration parameters.
3
When you have finished typing the configuration parameters, type exit or quit (depending on
your system).
When prompted whether to save settings that you have changed, enter Y (default) for Yes, or N
for No.
If you enter save instead of exit or quit, you will not be prompted to save settings.
Telnet Commands and Parameters.
available Telnet commands and parameters.
NOTE
its value cannot be changed using Telnet without first setting Manual configuration. To set
Manual configuration, see the ip-config command.
Whenever you are manually changing an IP address, you should also reconfigure the subnet
mask and default gateway at the same time.
Table 3-3
Telnet Commands and Parameters
Command
User Control Commands
?
/
menu
advanced
ENWW
During a Telnet session, enter ? to view available configuration parameters, the
If a parameter is supplied dynamically (for example, from a BOOTP or DHCP server),
Description
Displays the Help and Telnet commands.
Displays current values.
Displays the
Enables the Advanced commands. Help (?) will include the Advanced commands in the
list.
for configuration parameters.
Table 3-3 Telnet Commands and Parameters
Menu Interface
for access to configuration parameters.
lists the
IPv4 Configuration
45

Advertisement

Table of Contents
loading

This manual is also suitable for:

635n

Table of Contents