HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual page 45

Table 3-2 TFTP Configuration File Parameters (continued)
ipx-sapinterval:
■ Specifies the time interval (1 to 3600 seconds) that the HP Jetdirect print server waits between Service Advertising
Protocol (SAP) broadcasts on the network. The default is 60 seconds. 0 disables SAP broadcasts.
ipx-nds-tree:
■ Identifies the name of the Novell Directory Services (NDS) tree for this printer.
ipx-nds-context:
■ An alphanumeric string, up to 256 characters, that specifies the NDS context for the HP Jetdirect print server.
ipx-job-poll:
■ Specifies the time interval (seconds) that the HP Jetdirect print server will wait to check for print jobs in a print queue.
pjl-banner:
■ Enables or disables printing an IPX banner page. 0 disables banner pages. 1 (default) enables banner pages.
pjl-eoj: (or ipx-eoj:)
■ Enables or disables IPX end-of-job notification. 0 disables, 1 (default) enables.
pjl-toner-low:
■ Enables or disables IPX toner-low notification. 0 disables, 1 (default) enables.
AppleTalk
appletalk: (or at-config:, ethertalk:)
■
Enables or disables AppleTalk (EtherTalk) protocol operation on the print server: 0 disables, 1 (default) enables.
DLC/LLC
dlc/llc-config:
■ Enables or disables DLC/LLC protocol operation on the print server: 0 disables, 1 (default) enables.
Other Settings
link-type:
■ (For wired 10/100/1000T Ethernet) Sets the print server's link speed (10, 100, 1000 Mbps) and communication mode
(Full- or Half-Duplex). The available link-speed selections depend on the print server model. Selections are AUTO,
1000FULL, 100AUTO, 100FULL, 100HALF, 10FULL, 10HALF.
For AUTO (default), the print server uses auto-negotiation to configure itself with the highest link speed and
communication mode allowed. If auto-negotiation fails, either 100TX HALF or 10TX HALF is set depending on the
detected link speed of the hub/switch port. (A 1000T half-duplex selection is not supported.)
upgrade:
■ To configure one or more Jetdirect print servers with the name and location of a firmware upgrade file.
ENWW
(or ipx-banner:)
(or ipx-toner-low:)
(or dlc/llc:)
IPv4 Configuration 35