Classic Control Panel Eio Menus - HP 630n - JetDirect Gigabit EN Print Server Administrator's Manual

Classic control panel EIO menus

Classic control panels are provided on older devices that support HP Jetdirect EIO print servers only.
Classic control panels typically display two lines of 16 characters each. Use the available device keys
to display and select HP Jetdirect settings. Typically, an asterisk (*) identifies the selected value.
Figure C-2
Table C-2 HP Jetdirect EIO Menu on Classic Control Panel
Menu Item
CFG NETWORK
TCP/IP
IPX/SPX
DLC/LLC
ATALK
CFG TCP/IP
ENWW
Example of Classic Control Panel
Description
Access the HP Jetdirect menu. You must set this to
menu.
NO (default): Bypass the HP Jetdirect menu.
YES: Access the HP Jetdirect menu.
Enable the selected protocol stack.
ON: Enable the protocol.
OFF: Disable the protocol.
NOTE: The factory default setting depends on the print server model. On HP Jetdirect 635n
print servers, all network protocols except TCP/IP are disabled by default..
Access the TCP/IP menu and set TCP/IP protocol parameters.
NO (default): Bypass the TCP/IP menu.
YES: Access the TCP/IP menu.
●
BOOTP=YES*
●
DHCP=YES*
If DHCP=YES*
DHCP settings:
◦
RELEASE: Select whether to release (YES) or save (NO) the current lease.
◦ RENEW: Select whether to renew
●
AUTO IP=YES*
Enable IPv4 configuration by a BootP Server.
Enable IPv4 configuration by a DHCP Server.
and the print server has a DHCP lease, you can configure the following
(YES
Automatically assign a link-local IPv4 address in the form 169.254.x.x.
YES* each time you want to access the
or NO) the lease.
Classic control panel EIO menus 177