Resetting Print Server To Factory Defaults (Cold Reset) - HP En3700 - JetDirect Print Server User Manual

Resetting print server to factory defaults
(cold reset)
HP Jetdirect en3700 fast ethernet external print server
Once you configure the HP external print server, the configuration settings are retained
in memory unless you manually reset them to factory defaults.
To reset the print server configuration to factory defaults, follow these steps:
1. Unplug the power module from the back of the print server.
2. While holding down the test button on the back of the print server, plug the power
module back into the print server and continue to hold down the test button for
about five seconds. Any user-configured settings will be erased.
When the procedure is done, the print server responds exactly like it was fresh from the
factory.
Chapter 4 Troubleshooting
4-7