Resetting To Factory Defaults - HP 635n - JetDirect IPv6/IPsec Print Server Administrator's Manual

Resetting to Factory Defaults

Parameters on the HP Jetdirect print server (for example, the IP address) can be reset to factory default
values using the following procedures:
CAUTION:
values. However, a Certificate Authority (CA) certificate installed to validate a network
authentication server will not be saved.
NOTE:
to confirm that factory-reset values have been assigned.
● HP Jetdirect External Print Servers
Reset the HP Jetdirect external print server by holding down the Test button on the print server
while connecting the power cord.
● HP LaserJet Printer with Internal EIO Print Server
In most cases, the HP Jetdirect internal print server can be reset to factory defaults when a cold-
reset is performed on the printer.
CAUTION:
Resetting the printer will clear all data from the printer memory and reset all printer settings,
including network configurations, to their factory default values. After a cold reset, users may
be affected due to changes in user-specified printer settings. Network clients may lose their
connection to the printer.
●
For older HP LaserJet printers, a cold-reset is performed by power cycling the printer while
pressing the Go, Start, or Pause/Resume button.
●
For recent HP LaserJet printers/MFPs, use the same procedures as for Jetdirect embedded
print servers, described below.
●
For other printers, refer to your printer manuals. Or, visit
search for document file bpj02300.html.
●
HP LaserJet Printers/MFPs with Embedded Jetdirect Print Server
HP Jetdirect embedded print servers can be reset to factory defaults when a cold-reset is performed
on the printer.
CAUTION:
Resetting the printer will clear all data from the printer memory and reset all printer settings,
including network configurations, to their factory default values. After a cold reset, users may
be affected due to changes in user-specified printer settings. Network clients may lose their
connection to the printer.
NOTE:
not reset the HP Jetdirect print server.
●
For recent LaserJet printers and MFPs, use the printer's Service menu accessed during the
initial power-on sequence. See
● For other printers, refer to your printer service manuals.
118 Chapter 7 Troubleshooting the HP Jetdirect Print Server
A Jetdirect X.509v3 certificate will be saved over a cold reset to factory default
When you attempt to reset to factory default values, print a Jetdirect configuration page
Be sure to print a Jetdirect configuration page before performing a cold reset.
Be sure to print a Jetdirect configuration page before performing a cold reset.
The Restore Factory Settings menu item in the printer control panel menu will
Example: Cold Reset Using the Service Menu on page
http://www.hp.com/support and
119.
ENWW