Resetting Print Server To Factory Defaults (Cold Reset) - HP Jetdirect 310x - Print Server For Fast Ethernet User Manual

Resetting print server to factory
defaults (cold reset)
for HP Jetdirect 175x external print server/Internet connector for
and HP Jetdirect 310x external print server/Internet connector for
Once you configure the HP print server, the configuration settings
are retained in memory unless you manually reset them to factory
defaults.
To reset the print server configuration to factory defaults, follow
these steps:
1. Unplug the power module from the back of the print server.
2. While holding down the test button
print server, plug the power module back into the print
server and continue to hold down the test button
for about five seconds. Any user-configured settings will be
erased.
When the procedure is done, the print server responds exactly like
it was fresh from the factory.
configuration.
on the back of the
See a description of this default
©2000, 2001 Hewlett-Packard Company
USB
USB
button