Power - Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual

JUNOS 10.4 Protected System Domain Configuration Guide

power

Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
power (On) power (On)
power (Cycle)
power (State)
224
power -T target (-on | -off | -cycle | -state)
Command supported by Junos OS Release 9.1 and later.
(JCS management module CLI) Power on or power off a specified Routing Engine (blade)
or JCS switch module. Alternatively, display the power setting for a specified Routing
Engine or switch module.
-T target —Specify the target of the
—Specify a Routing Engine as the command target. Replace
system:blade[x]
the Routing Engine slot number (
—Specify a JCS switch module as the command target. Replace
system:switch[x]
with the switch number (
-on —Turn on the specified Routing Engine or JCS switch module.
—Turn off the specified Routing Engine or JCS switch module.
-off
-cycle —Cycle power for the specified Routing Engine or JCS switch module. If the Routing
Engine or JCS switch module is off, it will turn on. If the Routing Engine or JCS switch
module is on, it will turn off.
—Display the current power state (
-state
JCS switch module.
supervisor
reset on page 227
power (On) on page 224
power (Cycle) on page 224
power (State) on page 224
When you enter this command, you are provided feedback on the status of your request.
system> power –T system:switch[1] —on
OK
system> power –T system:switch[1] —cycle
Off
system> power –T system:blade[3] —state
On
power command. Valid targets for this command are:
1 through 12 ).
or ).
1 2
or ) for the specified Routing Engine or
on off
x
Copyright © 2010, Juniper Networks, Inc.
with
x