Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual page 176

JUNOS 10.4 Protected System Domain Configuration Guide
Results
152
peer-interface peer-interface
interfaces together. Use the following
For unit 0 , the value is
For , the value is
unit 1
For unit 2 , the value is
—Bind the 802.1Q VLAN tag ID to the logical interface. Use the following
vlan vlan-id
vlan-id values:
For , the value is
unit 0
For unit 1 , the value is
For , the value is
unit 2
family inet address address
on the logical Gigabit Ethernet interface. Use the following
For unit 0 , the value is
For , the value is
unit 1
For , the value is
unit 2
Display the results of the configuration:
interfaces {
ut-1/0/0 {
unit 0 {
peer-interface ge-6/0/0.0;
}
unit 1 {
peer-interface ge-6/0/0.1;
}
unit 2 {
peer-interface ge-6/0/0.2;
}
}
ge-6/0/0 {
vlan-tagging;
shared-interface;
unit 0 {
peer-interface ut-1/0/0.0;
vlan-id 16;
family inet {
address 10.70.0.1/30;
}
}
unit 1 {
peer-interface ut-1/0/0.1;
vlan-id 17;
family inet {
address 17.17.17.1/30;
—Bind the Gigabit Ethernet and tunnel interface
peer-interface
ut-1/0/0.0 .
.
ut-1/0/0.1
ut-1/0/0.2 .
.
16
17 .
.
18
—Configure the IP version 4 (IPv4) suite protocol family
10.70.0.1/30 .
.
17.17.17.1/30
.
18.18.18.1/30
Copyright © 2010, Juniper Networks, Inc.
values:
values:
address