Ifconfig (Jcs Switch Module) - Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual

ifconfig (JCS Switch Module)

Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Copyright © 2010, Juniper Networks, Inc.
Chapter 8: Summary of JCS Management Module Configuration Commands
ifconfig -T system:switch[x] <-c static> <-em (enabled | disabled)> <-ep (enabled |
disabled)> <-g gateway-address> <-i static-ip-address> <-s subnet-mask>
Command supported by Junos OS Release 9.1 and later.
(JCS management module CLI) Configure or display the JCS switch module Ethernet
interface.
—Specify a JCS switch module as the command target. Replace
-T system:switch[x]
with the primary management module number (
only valid target available for this command.
NOTE: For redundancy, you must configure the Ethernet interface for both
JCS switch modules.
—(Optional) Specify static IP configuration.
-c static
—(Optional) Enable or disable external management of all ports
-em (enabled | disabled)
on the JCS switch module.
-ep (enabled | disabled) —(Optional) Enable or disable external ports on the JCS switch
module.
—(Optional) Gateway IP address of the Ethernet interface on the JCS
-g gateway-address
switch module.
—(Optional) Static IP address of the Ethernet interface on the JCS
-i static- ip-address
switch module.
—(Optional) Subnet mask of the Ethernet interface on the JCS switch
-s subnet-mask
module.
operator (display)
supervisor (display or configure)
Configuring the Switch Module Ethernet Interface on page 41
ifconfig (Display) on page 68
ifconfig (Configure) on page 68
or ). The JCS switch module is the
1 2
x
67