Table of Contents
Advertisement
JUNOS 10.4 Protected System Domain Configuration Guide
Before You Configure Inter-PSD Forwarding
Related
Documentation
Configuring Inter-PSD Forwarding on a PSD
108
Before you configure inter-PSD forwarding, remember that each PSD that uses inter-PSD
forwarding must have a tunnel PIC available to it. To configure the cross-connection
between PSDs, a new interface type,
PSDs configured for inter-PSD forwarding must be running Junos OS Release 9.5 or later.
Currently, only Frame Relay encapsulation is supported for inter-PSD forwarding.
Inter-PSD Forwarding Overview on page 8
Configuring Inter-PSD Forwarding on a PSD on page 108
To configure inter-PSD forwarding on a PSD:
Use the
xt-fpc/pic/slot
1.
cross-connections with the other PSDs.
Configure logical interfaces under the cross-connect interface using the
2.
statement at the
logical-unit-number
The values for
logical-unit-number
(RSD) configuration.
For each logical interface, include the following statements:
3.
peer-psd psdn
—Configure a peer PSD. The PSD identification is a numeric value
with a range of 1 though 31.
peer-interface interface-name
the logical interface.
encapsulation frame-relay
Frame Relay encapsulation is supported for inter-PSD forwarding.
—Configure the interface as a point-to-point interface.
point-to-point
—Configure the data-link connection identifier (DLCI) for the
dlci dlci-number
point-to-point interface.
family family-name
—Configure the protocol family for the interface.
Repeat this procedure for each PSD that you want to include in inter-PSD forwarding.
4.
In the example illustrated in Figure 12 on page 109, a cross-connect using a tunnel interface
transports packets between the logical interfaces configured on each PSD.
, is implemented in Junos OS Release 9.5. All
xt
statement at the
[edit interfaces]
[edit interfaces xt-fpc/pic/slot]
must match values set in the Root System Domain
—Configure the tunnel peer interface that is bound to
—Configure Frame Relay encapsulation. Currently, only
hierarchy level to configure
unit
hierarchy level.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
