Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual page 123

SONET (PSD1)
Copyright © 2010, Juniper Networks, Inc.
Configure the IP address of the logical interface using the
8.
at one of the following hierarchy levels:
logical-unit-number family family]
logical-unit-number family family]
logical-unit-number family family]
Configure the physical tunnel interface using the
9.
hierarchy level.
interfaces]
Configure the logical tunnel interfaces using the
10.
at the
[ut-fpc/pic/slot]
The logical unit number must match the value of the logical unit number for the
physical shared interface. For example, if the shared interface logical unit is
of ), configure
so-0/0/0.1
For each logical tunnel interface, specify the logical peer interface on the SONET,
11.
Gigabit Ethernet, or 10-Gigabit Ethernet PIC using the
[ut-fpc/pic/slot unit logical-unit-number]
As described in Step 10, the logical unit number for the shared interface and the uplink
tunnel interface must match.
In the following example, logical SONET interface
tunnel interface
ut-1/0/0.0
interfaces {
so-0/0/0 {
encapsulation frame-relay;
shared-interface;
unit 0 {
dlci 100;
peer-interface ut-1/0/0.0;
family inet {
address 10.10.10.1/24;
}
}
unit 1 {
dlci 101;
peer-interface ut-1/0/0.1
family inet {
address 10.10.11.1/24;
}
}
}
ut-1/0/0 {
unit 0 {
peer-interface so-0/0/0.0;
}
unit 1 {
peer-interface so-0/0/0.1;
}
}
}
[edit interfaces so-fpc/pic/slot unit
, or [edit interfaces ge-fpc/pic/slot unit
, or
[edit interfaces xe-fpc/pic/slot unit
.
ut-fpc/pic/slot
unit logical-unit-number
hierarchy level.
as the logical peer tunnel interface.
ut-0/0/0.1
hierarchy level.
so-0/0/0.0
and is peered with
so-0/0/0.1
Chapter 11: Configuring Shared Interfaces
statement
address address
statement at the
statement
1 (as part
statement at the
peer-interface
is peered with logical
.
ut-1/0/0.1
[edit
99