Table of Contents
Advertisement
JUNOS 10.4 Protected System Domain Configuration Guide
170
At the
3.
[edit protocols bgp]
the routing group.
At the
[edit protocols bgp group int]
4.
a. Include the
type internal
b. Include the
local-address 10.12.1.2
end of a BGP session. This address is used to accept incoming connections to
the peer and to establish connections to the remote peer.
c. Include the
export nh-self
exported from the routing table into BGP.
d. Include the
neighbor 10.12.1.1
peer (neighbor) of Router 1. You do not need to include neighbor statements for
Router 2 or Router 3.
At the
[edit protocols]
5.
on the router.
At the
6.
[edit protocols ospf]
specify the area identifier for this router to use when participating in OSPF routing.
All routers in the area must use the same area identifier to establish adjacencies.
At the
[edit protocols ospf area 0.0.0.0]
7.
statement to configure the Gigabit Ethernet interface in the backbone area.
At the
[edit protocols ospf area 0.0.0.0]
8.
ge-1/1/0.0
statement to configure the Gigabit Ethernet interface in the backbone
area.
At the
[edit policy-options]
9.
statement to define the
A routing policy contains one or more terms. The
includes three terms (
exported from the routing table into BGP.
At the
10.
[edit policy-options nh-self]
define the first term for the
At the
[edit policy-options nh-self term a]
11.
statements to specify that any static route with destination prefix
rejected:
from {
protocol static;
route-filter 0.0.0.0/0 exact;
}
then reject;
At the
[edit policy-options nh-self]
12.
define the next term for the
At the
[edit policy-options nh-self term b]
13.
statements:
hierarchy level, include the
hierarchy level:
statement to configure an internal BGP group.
statement to specify the address of the local
statement to apply the
statement to specify the route reflector (RR) as
hierarchy level, include the
hierarchy level, include the
hierarchy level, include the
hierarchy level, include the
hierarchy level, include the
policy.
nh-self
,
and
). This policy is applied to routes
term a
term b,
term c
hierarchy level, include the
policy.
nh-self
hierarchy level, include the following
hierarchy level, include the
policy.
nh-self
hierarchy level, include the following
statement to define
group int
policy to routes being
nh-self
statement to enable OSPF
ospf
statement to
area 0.0.0.0
interface ge-1/1/1.0
interface
policy-statement nh-self
policy you are defining
nh-self
statement to
term a
0.0.0.0/0
term b
statement to
Copyright © 2010, Juniper Networks, Inc.
is
Advertisement
Table of Contents
