Ntp; Table 12: Ntp Output Fields - Juniper JUNOS OS 10.4 - PROTECTED SYSTEM DOMAIN Configuration Manual

JUNOS 10.4 Protected System Domain Configuration Guide

ntp

Syntax
Release Information
Description
Options
Required Privilege
Level
Related
Documentation
List of Sample Output
Output Fields
72
ntp -T system:mm[x] <-en (enabled | disabled)> <-i ip-address | hostname> <-f
update-frequency> <-synch>
Command supported by Junos OS Release 9.1 and later.
(JCS management module CLI) Configure or display the JCS management module
network time protocol (NTP) settings.
—Specify a JCS management module as the command target. Replace
-T system:mm[x]
with the primary management module number (
x
is the only valid target available for this command.
—(Optional) Enable or disable NTP for the JCS management
-en (enabled | disabled)
module.
-i ip-address|hostname —(Optional) IP address or hostname of the NTP server.
—(Optional) Update frequency (in minutes). The JCS management
-f update-frequency
module clock is automatically updated at the frequency specified. Replace
update-frequency with a value from
—(Optional) Synchronize the JCS management module clock with the NTP server.
-synch
operator (display)
supervisor (display or configure)
Configuring the NTP Server on page 42
ntp (Display) on page 73
ntp (Configure) on page 73
Table 12 on page 72 lists the output fields for the
in the approximate order in which they appear.

Table 12: ntp Output Fields

Field Name
-en
-i
-f
-v3en
or
1
1 through 45000 .
command. Output fields are listed
ntp
Field Description
NTP status ( or
enabled disabled
IP address or hostname of the NTP server.
How often (in minutes) the JCS management module is updated
by the NTP server.
V3 authentication status ( enabled
management module and the NTP server.
). The JCS management module
2
).
or disabled ) between the JCS
Copyright © 2010, Juniper Networks, Inc.