Component-Specific Configuration - Novell NETWARE 6-DOCUMENTATION Manual

Component-Specific Configuration

NFS Server
Network Information Service
116 Novell Native File Access Protocols Installation and Administration Guide
3
Click the Policies tab on the property page.
4
View or change the Start, Failover, or Failback mode.
The procedure to configure the components of Native File Access for UNIX
is much the same as when you configure the components without cluster
services. However, some points must be kept in mind while configuring the
following components:
NFS Server (page 116)
Network Information Service (page 116)
For the location of the configuration files for Native File Access for UNIX
with and without Cluster Services, see
page 117.
While configuring the NFS Server, note the following:
Export only the shared volumes from NFS Server. For exporting other
shared volumes, make sure you mount those volumes in the load script by
adding the following before the nfsclust entry:
mount volumename volid = 253 or lesser than this number
After this, deactivate and dismount them in the unload script:
dismount volumename
When mounting from an NFS client, use the virtual IP address of the
cluster volume object.
For more information on configuring the NFS Server, see
Based Management for NFS Server" on page
While configuring the NIS clients, note the following:
Bind the NIS clients to NIS server running on the cluster using a virtual
IP address.
"Location of Configuration Files" on
"ConsoleOne-
87.