Configuring Load Balancing; Configuring Fault Tolerance - Novell NETWARE 6-DOCUMENTATION Manual

Configuring Probe Timeout

Configuring Load Balancing

Configuring Fault Tolerance

1
Load INETCFG and then select Protocols > TCP/IP > Dead Gateway
Detection Configuration.
2
Select Probe Timeout and then enter a value in seconds.
3
Press Esc until you are prompted to save your changes, and then select
Yes.
4
Press Esc to return to the Internetworking Configuration menu.
5
If you want these changes to take effect immediately, select Reinitialize
System > Yes.
Before you configure load balancing check whether you have bound the
desired NIC. If not, go to
1
Load INETCFG and select Protocols.
2
Select TCP/IP from the list of Protocols.
3
Select Load Balancing and enable it.
This switch is for the complete system. You still have to configure load
balancing on your network.
4
Select Load Balancing Configuration.
5
Configure Load Balancing Interval and Configure Individual Groups.
6
In Configure Individual Groups, select the network listed and enable load
balancing.
Before you configure fault tolerance check whether you have bound the
desired NIC. If not, go to
1
Load INETCFG and select Protocols.
2
Select TCP/IP from the list of Protocols.
3
Select Fault Tolerance and enable it.
This switch is for the complete system. You still have to configure fault
tolerance on your network.
"Binding Protocols" on page 52
"Binding Protocols" on page 52
to do so.
to do so.
75
Protocols