Unloading Sbcon; Loading Nwback32 - Novell NETWARE 6-DOCUMENTATION Manual

Unloading SBCON

Loading NWBACK32

To ensure maximum memory utilization and throughput, you should unload
backup software and other Storage Management Services
when you are finished performing your backup. That way, more memory will
become available on your host or target.
1
Exit SBCON from the Main Menu.
Press Esc until you reach the SBCON Main Menu; then press Esc again
and confirm the prompt.
2
Unload all the modules by entering the following command at the server
console:
SMSSTOP
Unloads all the previously loaded SMS modules.
WARNING:
The system displays a warning message on the console if you
attempt to unload a module being used by another NLM. If you continue, your
server might abend.
1
Log in to the desired eDirectory
If this is the first time you have used NWBACK32, go to
47 Otherwise, go to
2
(Conditional) If this is the first time you have used NWBACK32, do the
following:
2a
Log in to the server running the backup engine.
2b
Enter your user name and password.
2c
Configure eDirectory information.
Tree Name. Enter the name of the eDirectory tree you will be using
to backup and restore data.
SMDR Context. Enter the context you created during the server
configuration.
SMDR Group Context. Enter the context you created during the
server configuration.
Check the SAP (IPX) box if you want to use IPX. Uncheck the box
for IP.
tree structure.
TM
Step 3 on page 48.
(SMS ) modules
TM TM
Step 2 on page
47
Setting Up