Monitoring Tcp/Ip Information; Checking The Tcp/Ip Routing Table; Monitoring The Configured Tcp/Ip Protocols - Novell NETWARE 6-DOCUMENTATION Manual

Monitoring TCP/IP Information

Checking the TCP/IP Routing Table

Monitoring the Configured TCP/IP Protocols

92
NetWare TCP/IP Administration Guide
Monitoring TCP/IP information can give you a clear view of the status of your
TCP/IP network and whether the router is configured properly to run
efficiently in the network. This information can also be helpful in
troubleshooting and optimizing of the network.
To check the TCP/IP routing table and information associated with each route,
load TCPCON and select IP Routing Table > Proceed > entry you want to
view.
The IP Routing Table window shows you all known TCP/IP destination
networks and the following information about each item:
IP address of the destination
IP address of the next hop router
Type of the route (direct, remote)
Primary cost for the route
Interface used to reach a route
The IP Route Information window expands on this by showing information
about the mask used, the routing protocol through which the destination was
learned, and the age of the route.
You can view, and sometimes change, the configuration of TCP/IP protocols
configured for use in your router. You can reach this information by loading
TCPCON and selecting Protocol Information. You can configure and view
statistics and other information for the following protocols:
EGP
ICMP
IP
OSPF
TCP
UDP
For additional information about each protocol, press F1 to access online help.