Novell NETWARE 6-DOCUMENTATION Manual page 1769

Checking Write Access on the Remote Router
58
Internetwork Packet Exchange
Write Connection Routing Tables to Permanent Storage —Sends IPX
SNMP requests to the local and remote routers to save the current local
and remote routing tables for this connection to permanent storage. Each
router is polled to make sure the operation is completed.
Restore Connection Routing Tables from Permanent Storage —Sends
IPX SNMP requests to the local and remote routers to restore the local
and remote static routing tables for this connection from permanent
storage. Each router is polled to make sure the operation is completed.
For more information about configuring static routes and services
dynamically, refer to
page 59 and "Automatically Configuring Static Routes and Services" on page
62.
For STATICON to configure a remote router's routing and service tables, it
must support IPX SNMP and the IPX MIB variables and have SNMP-write
access to the router. If the remote router is running Novell Internet Access
Server 4.1, specifying a Control Community from NIASCFG enables write
access.
To check write access, complete the following steps:
1
Load NIASCFG on the remote router, then select the following parameter
path:
Select Configure NIAS > Protocols and Routing > Manage
Configuration > Configure SNMP Parameters
The Control State field should read Any Community May Write or
Specified Community May Write . If it reads Specified Community May
Write , note the name in the Control Community field. Use this name
when you must provide the name of the SNMP control community in
8 on page 59 of
Step 8 on page 63
Services.
2
Press Esc to return to the Internetworking Configuration menu.
3
Exit NIASCFG.
"Selectively Configuring Static Routes and Services" on
Selectively Configuring Static Routes and Services
of Automatically Configuring Static Routes and
Step
and