Event Reporting And Control By Telephone And Sms; Event Notifications By Telephone - Visonic PowerMaster-10 G2 User Manual

EVENT REPORTING & CONTROL BY TELEPHONE AND SMS

7. Event Reporting and Control by Telephone and SMS

Event notifications by Telephone

The PowerMaster can be programmed for selective notification of event messages to private telephone
subscribers – See Chapter – 6, B.12 Programming Private Phone, Email, MMS and SMS Reporting. Messages
are divided by type into the following groups:
Group Events Reported
1 Fire, Burglary, Panic, Tamper
2* Arming AWAY, Arming HOME, Disarming
3 No-activity, Emergency, Latchkey, Gas, Flood, Temperature
4* Low-battery AC failure
* PowerMaster-30 G2 only
Note: For UL installations, SMS is a supplementary feature.
PowerMaster-10 G2 control panels
In case of alarm the following voice signal will be sent to private telephones upon event reporting:
* FIRE: ON - ON - ON - pause....
** BURGLAR: ON continuously (
*** EMERGENCY: 2-tone siren; like an ambulance.
To stop the alarm notification – press the "2" key on your telephone keyboard. The alarm sound will stop
immediately.
The called party must acknowledge the message (as explained later on). However, if there is no response the
message will be repeated as many times as possible within a 45-second time limit. When the 45 seconds are
up, the PowerMaster will disengage the line and call the next private telephone number on its list.
The called party must acknowledge the message by pressing the "2" key on the telephone keypad. As a result,
the PowerMaster may continue to notify the next programmed telephone number, or if so programmed, consider
the event as reported - see Chapter – 6, B.11.
PowerMaster-30 G2 control panels
When the called party answers a call initiated by the PowerMaster, he will hear a verbal message composed of the
"house identity" and the type of event that occurred. For example, once smoke is detected in the Smith residence,
the message will be:
[The Smith Residence - Fire Alarm].
If a person under surveillance in the Watkins residence has been inactive, the message will be:
[The Watkins Residence - No Activity].
The called party must acknowledge the message (as explained later on), but if he does not respond, the
message will be transmitted repeatedly as many times as possible within a 45-second time limit. When the 45
seconds are up, the PowerMaster will disengage the line and call the next private telephone number on its list.
The called party can acknowledge the message by pressing a key on the telephone keypad, as follows.
Command
Acknowledge only: The PowerMaster disengages the line and considers the event duly reported.
Acknowledge and listen-in: The protected site is "bugged" for sound for 50 seconds. The called party
may prolong the listening session by pressing [3] again before the PowerMaster disengages the line, or
by pressing [1] to speak.
Acknowledge and speak out: The called party may speak for 50 seconds to whoever is in the
protected site. The called party may prolong the "speak out" session by pressing [1] again before the
PowerMaster disengages the line, or by pressing [3] to listen.
Acknowledge and 2-way conversation: You and the called party can speak and listen without any
necessity to switch the system from "listen-in" to "speak-out" and vice versa for 50 sec. (extendable).
Acknowledge and request a status report: The PowerMaster will issue a verbal report of system
status. For example:
[Disarm - ready to arm] or
[Disarm - back door open] or
[Disarm - alarm in memory].
D-304829 PowerMaster-10/30 G2 User's Guide
(- - - - - -
......).
...)
Key
2
3
1
6
9
49